132 MultiModemISI Hybrid Series, ISIHI-2S
Appendix
For example, if the base IO address switch setting were changed to 2C0h, the new
command line would be: A:\>608TERM -A2C0
The following displays:
A:\>608TERM -A2C0
Loading Firmware to ISI608 located at address 2C0h
Loading default file: ISI608.BIN
ISI608 loading firmware . . .
ISI608 verifying firmware . . . Verify OK.
ISI608 firmware loaded successsfully.
ISI firmware loaded successfully . . .
Enter 1 to 8 for eight ports ISI.
Enter port number ?
The first step in this utility is to identify the port to be tested. In order for the test to
function, the selected port must be connected to a modem that is switched on. Valid
entries for the MutiModemISI are 1 through 8. Once a port is selected, the following
displays:
Enter 8 == 1200 baud
Enter 11 == 2400 baud
Enter 15 == 9600 baud
Enter 16 == 19200 baud
Enter 17 == 38400 baud
Enter 18 == 57600 baud
Enter 19 == 115200 baud
Enter the baud rate you wish to run?
This step allows selection of a baud rate for testing. Once a baud rate is selected, the
following displays:
ISI Terminal Utility is ready. Press F10 to Exit./
This message indicates that keyboard entry can now be performed. Any characters typed
on the keyboard are sent through the ISI board to the modem and then returned to
display on the PC. When operation has been verified, exit the utility by pressing F10.