156 MultiModemISI Hybrid Series, ISIHI-2S
Appendix
\X
n
XON/XOFF Pass-Through
n
= 0
\X0 Respond to and discard XON\XOFF characters
Y
n
Long Space Disconnect
n
= 0
Y0 Disable sending or responding to long space break signal on disconnect.
&Y
n
Select Stored Configuration for Hard Reset
n
= 0
&Y0 Select stored configuration 0 at power-up (included for backward compatibility with some
software)
Z Modem Reset
Reset modem to default values. Defaults from NVRAM if &W0 is set; from ROM if &W1 is set.
&Z
n
=
x
Store Telephone Number
n
= 0-3,
x
= dialing string
Stores telephone dial string
x
in memory location
n
. Dial the stored number using the command
ATDS=
n
.
, Dialing Pause
In dial command
Comma; causes dialing pause for time set by S8.
;Return to Command Mode After Dialing
At end of dial command
Semi-colon; causes immediate return to command mode after dialing
! Flash On-Hook
In dial command
Exclamation; causes modem to flash on-hook.
$ Detect Call Card
In dial command
Causes modem to pause and wait for an AT&T call card
bong
or a 1600 Hz tone before
processing the rest of the dial string.
@ Quiet Answer
In dial command
Causes modem to wait for a ringback, then 5 seconds of silence before processing next part of
command.
^ Disable Data Calling Tone Transmission
In dial command
The modem does not transmit data calling tones.
+++AT<cr> Escape Sequence
Puts modem in command mode while still remaining on line. Type +++ followed by the letters A
and T, up to ten command characters and a RETURN.