Multi Tech Equipment MTA128ST manual AppendixAConfiguration Profiles, Quick Setup Factory Profiles

Appendices

AppendixA:Configuration Profiles

Quick Setup Factory Profiles

For quick setup, the MTA1 28ST/NT includes six Quick Setup Factory Profiles, each of which is configured for a specific type of port operation. You can load a Quick Setup Factory Profile into active memory by using the command &Fn, in which n is the number of the profile you wish to load. If you wish, you can then customize the profile and store it, using the &Wcommand, so that it loads automatically when the MTA1 28ST/NT is turned on or reset. These profiles are stored in permanent memory and are not user-configurable as such.

MTA1 28ST

&F0 Profile 0—Modem-like operation (default) &F1 Profile 1—V. 110 async operation

&F2 Profile 2—V.120 async operation &F3 Profile 3—X.75 async operation &F4 Profile 4—ML-PPP async operation

&F5 Profile 5—SoftBonding Asynchronous Operation &F6 Profile 6—HDLC Asynchronous Operation &F7 Profile 7—CLEAR operation

MTA1 28NT

&F0 Profile 0–Modem-Like Asynchronous Operation

&F1 Profile 1–V.120 Asynchronous Operation

&F2 Profile 2–X.75 Asynchronous Operation

&F3 Profile 3–PPP Asynchronous Operation

&F4 Profile 4–SoftBonding Asynchronous Operation

&F5 Profile5–HDLC Asynchronous Operation

&F6 Profile 6–CLEAR Asynchronous Operation

Quick Setup Example

The following procedure assumes that you want to load, modify, and store Quick Setup Factory Profile 2 as your default configuration.

1.Select the profile closest to the requirements of your application, in this case— Quick Setup Factory Profile 2.

2.In terminal mode, type AT&F2 and press ENTER. Quick Setup Profile 2 loads into the MTA128ST/NT’s active memory.

3.Enter any additional AT commands that you need to customize the selected profile to your application (see Chapter 4, AT Commands, S-Registers, and Result Codes).

4.Type AT&W0 and press ENTER to save your customized port configuration.

5.Your customized profile now loads automatically whenever the MTA128ST/NT is turned on or reset.

MTA128ST/NT 43