DCA-10SPX4 — GENERATOR START-UP PROCEDURE
Before Starting
CAUTION - LETHAL EXHAUST HAZARD
The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.Direct exhaust away from nearby personnel.
WARNING - STARTINGTHE GENERATOR
NEVER! manually start the engine with the main, GFCI or auxiliary circuit breakers in the ON (closed) position.
1.Place main, GFCI, and aux. circuit breakers (Figure 20) on the controll panel in the OFF position prior to starting the engine.
Start-up Procedure
1.Set the Speed Control Switch to the START/IDLE position (Figure 22).
Figure 22. Speed Control Switch (START/IDLE)
2.Insert the ignition key into the ignition switch. Turn the key clockwise to the
Figure 20. Main, GFCI, and Auxillary
| Circuit Breakers (OFF) |
|
NOTE | Generator may not be equipped with |
|
auxiliary circuit breakers or |
| |
|
| |
| receptacles. This feature is optional | Figure 23. Ignition Switch |
3.Connect the load to the receptacles as shown in Figure 11. These load connection points can be found on the output terminal panel and the output terminal panel’s hard wire hookup panel.
4.Close all engine enclosure doors (Figure 21).
3.Once the engine starts, let it run for
4.The generator's frequency meter (Figure 24) should be displaying the 60 cycle output frequency in HERTZ.
Figure 21. Engine Enclosure Doors | Figure 24. Frequency Meter (Hz) |