Multiquip DCA-220SSVU— OUTPUT TERMINAL PANEL CONNECTIONS, 3Ø-480VUVWO Terminal Output Voltages

DCA-220SSVU — OUTPUT TERMINAL PANEL CONNECTIONS

3Ø-480V UVWO Terminal Output Voltages

1.Jumper the voltage change-over board for 480V operation as shown in Figure 26.This configuration uses 6 jumper plates in 3 different positions. Remember there are 2 jumper plates at every position. Every jumper plate must be used.

1Ø-480V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 480V operation as shown in Figure 26.

2.Connect the load wires to the UVWO terminals as shown in Figure 28.

Figure 26. Voltage Change-Over Board

480V Configuration

2.Connect the load wires to the UVWO terminals as shown in Figure 27.

Figure 28. UVWO Terminal Lugs

1Ø-480V Connections

1Ø-277V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 480V operation as shown in Figure 26.

2.Connect the load wires to the UVWO terminals as shown in Figure 29.

Figure 27. UVWO Terminal Lugs

3Ø-480V Connections

	ALWAYS make sure that the	Figure 29. UVWO Terminal Lugs
		1Ø-277V Connections
NOTE	connections to the UVWO
	terminals are secure and tight.
	The possibility of arcing exists,
	that could cause a fire.

DCA-220SSVU— OPERATION AND PARTS MANUAL — REV. #1 (01/20/06) — PAGE 31