Multiquip DCA25SSIU manual DCA-25SSIU— GENERATOR START-UPPROCEDURE

DCA-25SSIU — GENERATOR START-UP PROCEDURE

15.The charging ammeter will dindicate if the battery is being properly charged or if the any current is being charged properly.

Figure 45. Voltage Adjust Control Knob

12.The ammeter (Figure 46) will indicate zero amps with no load applied. When a load is applied, this meter will indicate the amount of current that the load is drawing from the generator’s alternator.

40

2060

075

A

Figure 46. Ammeter (No Load)

13.The engine oil pressure gauge (Figure 47) will indicate the oil pressure (kg/ cm2) of the engine. Under normal operating conditions the oil pressure is approximately 25 psi.

Figure 47. Oil Pressure Gauge

Figure 49. Charging Ammeter

16.The tachometer (Figure 50) will indicate the speed of the engine when the generator is operating. Under normal operating conditions this speed is approximately 1800 RPM’s.

Figure 50. Engine Tachometer

17.Turn the MAIN, GFCI and LOAD circuit breakers to their ON position (Figure 51).

14. The coolant temperature gauge (Figure 48) will indicate	Figure 51. Main and GFCI Circuit Breakers
the coolant temperature. Under normal operating
conditions the coolant temperature is between 165 and
215 degrees Fahrenheit.

WATER TEMP

Figure 48. Coolant Temperature Gauge

PAGE 45 — DCA-25SSIU — PARTS AND OPERATION MANUAL (STD) — REV. #7 (04/18/12)