Reset the Switch, Show or Set Snmp Configuration

Reset the Switch

Command Name	Reset
Description	Reset (reboot) the switch
Syntax	Reset
Parameters	None
Example	N-TRON/Admin> reset
	Preparing for reset.
	Cleaning up...
	Browser will be redirected to 192.168.1.250.
	Disabling SNMP...
	Disabling DHCP...
	Disabling CIP...
	Locking out other processes...
	Disable preemption...
	Resetting device...
	…
Notes
Show or Set SNMP Configuration
Command Name	Snmp
Description	Show or set SNMP configuration. If no parameters are specified, this command will
	show the SNMP configuration (same as -show parameter).
Syntax	snmp [-show] [-ro name] [-rw name] [-trap name]
Parameters	-show
	Show configuration.
	-ro name
	Set the Authorized Community Name for SNMP Get requests.
	-rw name
	Set the Authorized Community Name for SNMP Set requests.
	-trap name
	Set the Authorized Community Name for SNMP Traps.
Examples	N-TRON/Admin> snmp –ro users
	IP Address - Trap Stn.#1	: Value Not Configured
	IP Address - Trap Stn.#2	: Value Not Configured
	IP Address - Trap Stn.#3	: Value Not Configured
	IP Address - Trap Stn.#4	: Value Not Configured
	IP Address - Trap Stn.#5	: Value Not Configured
	Read-Only Community Name	: users
	Read-Write Community Name : private
	Trap Community Name	: public
	Changes have been made that have not been saved.
	…
NOTES	Community names may only contain alphanumeric, space, ‗-‗, ‗_‘, and ‗#‘ characters,
	and may not begin with a number, space, or underscore. A name with embedded space
	characters must be enclosed in quotes. The maximum length is 15 characters.

Page 142 of 159