N-Tron 710FX2 user manual Save or Reset the Configuration Settings, Show or Set Igmp Configuration

CLI Commands, Continued…

Save or Reset the Configuration Settings

Command Name	config
Description	Save or reset configuration settings
Syntax	config s[ave] r[eset]
Parameters	save
	save current running configuration settings.
	reset
	reset configuration settings to factory defaults.
Examples	N-TRON/Admin> config save
	Save Settings...
	Settings have been saved.
	N-TRON/Admin> config reset
	Resetting to factory defaults...
	Load factory default settings [y/n]?y
	Keep IP, subnet mask, and gateway addresses [y/n]?y
	Keep current user names and passwords [y/n]?y
	…
NOTES
Show or Set IGMP Configuration
Command Name	igmp
Description	Show or set IGMP configuration. If no parameters are specified, this command will show
	the IGMP configuration (same as -show parameter).
Syntax	igmp [-show] [-status state]
Parameters	-show
	Show configuration.
	-status state
	Set the IGMP status to e(nabled) or d(isabled).
Examples	N-TRON/Admin> igmp –show
	IGMP Status	: Enabled
	IGMP Version	: 2
	Query Mode	: Auto
	CIP Querier Status	: 2, Active-Auto
	Active Querier IP	: 192.168.1.250
	Router Mode	: Auto
	Manual Router Ports	: (None)
	IGMP Number of Groups	: 1
	IGMP Resource Usage % : 1
	N-TRON/Admin> igmp –status disabled
	IGMP Status	: Disabled
	IGMP Version	: 2
	Query Mode	: Auto
	CIP Querier Status	: 2, Active-Auto
	Active Querier IP	: 192.168.1.250
	Router Mode	: Auto
	Manual Router Ports	: (None)
	IGMP Number of Groups : 1
	IGMP Resource Usage % : 1
	N-TRON/Admin>…
NOTES

(Revised 2010-9-27) Page 137 of 159