GB NAD 517 COMPACT DISC PLAYER
FOR SAFE AND EFFICIENT OPERATION
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
The equipment is a sophisticated
Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight. Also avoid loca- tions subject to vibration and excessive dust, heat, cold or moisture. Keep away from such sources of hum as transformers or motors.
Do not use this unit where there are extremes in temperature (below 41°F/5°C or exceeding 95°F/35°C) or where direct sunlight may strike it.
Do not remove the top cover as this might result in damage to the player or electrical shock.
Be sure hands are clean when handling discs. Never insert a disc which has a crack on its surface.
When disconnecting the power cord from the wall outlet, always grasp it by the plug. Never tug the cord.
Do not use force when operating switches and buttons.
Before moving the set be sure to disconnect the power cord and all connecting cables.
To keep the
Do not attempt to clean the unit with chemical sol- vents as this may damage the finish. Use a clean, dry cloth.
DANGER: When the top cover is removed and the safety interlock is defeated or has failed, avoid direct exposure to invisible laser beam.
WARNING TO UK USERS. If this appartus is fitted with a
IMPORTANT. The wires in this mains lead are coloured BLUE and BROWN; BLUE: NEUTRAL
BROWN: LIVE
The colours of these mains lead wires may not corre- spond with the coloured markings identifying the ter- minals in your plug. In this case the BROWN wire must be connected to the terminal which is marked L(ive) or coloured RED. The BLUE wire must be con- nected to the terminal marked N(eutral) or coloured BLACK. No connection should be made to the termi- nal marked E or coloured green or green and yellow
CAUTION. ALWAYS REPLACE THE FUSE WITH THE SAME TYPE AND VALUE. DISCONNECT THE POWER SUPPLY FIRST.
NOTE:
Do not move this player with compact discs sets inside. Otherwise,the compact discs may become jammed inside the player.
Be sure to read
NAD
4
Keep this manual in a safe place for future reference.
NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses and can radi- ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow- ing measures:
-Reorientate or relocate the receiving antenna.
-Increase the distance between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT... This Digital Compact Disc Changer was developed to give you many years of enjoyment. Please read the following instructions carefully. They have been prepared to assist you during the initial
THE WARRANTY ON THIS UNIT DOES NOT COVER DAMAGE CAUSED BY
CONNECTING THE DIGITAL COMPACT DISC CHANGER (Please refer to Figure 1.)
CAUTION:
-Before making connections or disconnections, be sure to switch off the power to each component.
-Be sure to make the correct connections, paying attention to the L (left channel) and R (right channel) marks. Plug in the cables securely. Loose connec- tions will result in unsatisfactory sound reproduction or cause noise problems. Refer to Fig. 1.
-After all connections have been completed, con- nect the power cord of the main unit to either a household outlet or an auxiliary outlet on the amplifi- er.- If this unit interferes with the tuner, switch off the unit during tuner operation.
(1) LINE OUT SOCKETS.
Connect one end of the patch cords (supplied) to these sockets and the other end to the jacks desig- nated by CD, DAT, AUX, TAPE PLAY, T.V., TUNER, etc., on the amplifier. Do not connect it to the amplifi- er’s PHONO jacks.
Do not confuse the right (R) and left (L) cords when making connections. The white plug is for the left channel and the red plug is for the right channel.
