22
SPARK MODULE BATTERY REPLACEMENT
1.Remove optional front. (Instructions on Pg. 19)
2.Tilt the control panel forward and remove allowing access to the electode box which is screwed to the base of the fi rebox. (Fig. 53)
3.Pull back on the battery compartment door latch and remove.
4.Replace battery.
5.Reinstall battery compartment and control doors.
FIGURE 53
NIGHT LIGHT™ REPLACEMENT
Your 
comes equipped with our “Night Light™”. The light has been
If in the event the lamp or lens needs to be replaced, follow the instructions below.
Unplug the wire harness / transformer from the FCM (Fan Control Module) inside the fi replace.
FIGURE 54
LENSE
FRAME
FIGURE 55
SCREWS
FIREBOX TOP
Remove the four screws that | FIGURE 56 | |
secure the lens frame. |
| |
This frame retains the glass |
| |
lens. The lamp can now be |
| |
accessed. |
| |
Note: Do not handle the lamp | GASKET | |
(bulb) with bare fingers, protect | ||
| ||
with a clean dry cloth. | LENSE | |
The lamp will pull straight out | FRAME | |
of the socket. Replace with | ||
| ||
Wolf Steel parts only, as lamp |
| |
and lens are special “high |
| |
temperature” products. |
| |
When |
|
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the upper area may be observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
OPERATION
GENERAL TRANSMITTER LAYOUT
FIGURE 57
FIREPLACE OPERATION
1.Install 4 AA batteries into the receiver battery bay as indicated on the battery cover
2.Place the 3 position slider switch in the “Remote” position.
3.Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole marked “PRG” on the receiver front cover. The receiver will “beep” three (3) times to indicate that it is ready to synchronize with the transmitter.
4.Install the 3 AAA batteries in the transmitter as indicated in the battery bay, located on the base of the transmitter.
With the batteries already installed in the transmitter, push the “ON” button. The receiver will “beep” four times to indicate the transmitter’s command is accepted and set to the particular code of that transmitter. The system is now initialized.
