Operating Instructions

When lit for the ﬁ rst time, the ﬁreplace will emit a slight odor for a few hours. This is a normal temporary condition caused by the cur- ing of paints and lubricants used in the manufacturing process and will not occur again. Simply open a window to sufﬁ ciently ventilate the room.

After extended periods of non-operation such as following a vacation

or a warm weather season, the ﬁ replace may emit a slight odor for a few hours. This is caused by dust particles in the heat exchanger burning off. Open a window to sufﬁ ciently ventilate the room.

Purge all gas lines with the glass door of the ﬁreplace open. Assure that a continuous gas ﬂow is at the burner before closing the door.

FOR YOUR SAFETY READ BEFORE LIGHTING:

A.This ﬁ replace is equipped with a pilot which must be lit by hand while following these instructions exactly.

B.Before operating smell all around the ﬁ replace area for gas and next to the ﬂ oor because some gas is heavier than air and will settle on the ﬂ oor.

C.Use only your hand to turn the gas control knob / manual shut-off knob. Never use tools. If the knob will not turn by hand, do not try to repair it. Call a qualiﬁ ed service technician. Force or attempted re pair may result in a ﬁ re or explosion.

D.Do not use this ﬁ replace if any part has been under water. Immediately call a qualiﬁ ed service technician to inspect the ﬁ replace and replace any part of the control system and any gas control which has been under water.

WHAT TO DO IF YOU SMELL GAS

•Do not touch any electric switch.

•Do not use any phone in your building.

•If you cannot reach your gas supplier, call the ﬁ re department.

•Turn off all gas to the ﬁ replace.

•Do not try to light any appliance.

•Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s instructions.

FIGURE 74

GAS KNOB

LIGHTING INSTRUCTIONS

Warning: if you do not follow these instructions exactly, a ﬁre or explosion may result causing property damage, personal injury or loss of life. Initial lighting of the pilot and main burners must be done with the glass door off.

Do not connect valve or wall switch to electricity. See installation instructions.

When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob it depressed slightly.

1. STOP! Read the safety information on the operating la- bel.

2.Turn off all electric power to the ﬁ replace.

3.Turn the gas knob clockwise to off.

4.Wait 5 minutes to clear out any gas. If you smell gas, including near the ﬂ oor, STOP! Follow “B” on the op- erating label. If you don’t smell gas, go to the next step.

5.If the ﬁ replace is equipped with a ﬂ ame adjustment valve, turn clockwise to off.

6.Find pilot located in front of the back log on the right side.

7.Turn gas knob counter-clocKwise to pilot.

8.This unit is equipped with an auto-spark. Depress and hold gas knob . Keep knob fully de pressed for one minute, then release. If pilot does not continue to burn repeat steps 3 through 7.

9.With pilot lit, turn gas knob counter-clockwise to on.

10.If equipped with ﬂ ame adjustment valve, push and turn knob to high.

11.If equipped with remote on-off switch, main burner may not come on when you turn the valve to on or high. Remote switch must be in the on position to ignite burner.

12.Turn on all electric power to the ﬁ replace.

FIGURE 75

SOLENOID PILOT

ON/OFF

KNOB

TO TURN OFF GAS

1.Turn off all electric power to the ﬁ replace if service is to be performed.

2.For a complete shut-down procedure: push in gas control knob

slightly and turnclockwise to off. Do not force.

3.For a temporary shut-down procedure: set thermostat to low- est setting or remote switch to off. Press and turn the gas knob

clockwiseto pilot.

Napoleon Fireplaces GD82NT-PA, GD82PT-PA manual Operating Instructions, What to do if YOU Smell GAS

Models: GD82NT-PA GD82PT-PA