20
LOG PLACEMENT
NOTE: Decorative brick panels must be installed before the logs.
See installation instructions supplied with the panel kit.
PHAZERTM logs, exclusive to Napoleon® Fireplaces, provide a unique and realistic glowing effect that is different in every installation.
FIGURE 39 a-f
1
1.Place the rear log #1 onto the locating studs along the back edge of the PHAZERAM- IC™ burner.
4.Place log #4 with the charred
branch facing inward. Position | 4 |
the pin in log #4 into the hole on the right of log #2.
|
| 5. Place log #5 so the locating |
|
|
| hole on the bottom of the log |
|
2. Position log #2 in the 2 |
| sits on the screw and spacer. | 5 |
locating holes behind the |
|
|
|
andirons. |
| 2 |
|
|
| 6. Finally, align the rectangular |
|
3. Place log #3, with the |
| peg on log #6 with the notch |
|
| on the front right portion of | 6 | |
charred branch facing in- | 3 | ||
ward. Position the pin in log | the burner. |
|
#3 into the hole on the left of
the log #2. | GLOWING EMBERS | ||
Glowing embers are NOT recommended. The burner has been | |||
| |||
| designed to achieve maximum glow without embers. | ||
|
|
| |
| AFK / WI FACE KIT INSTALLATION | ||
1. Attach screw and spacer as illustrated in (Fig. 44) to the bottom of both sides of the front housing.
SCREW |
& |
SPACER |
2.Attach the face plate bracket provided to the top edge of the front housing using 2 #8 - 1/2” truss head screws as illustrated in (Fig. 45).
FIGURE 46
3.Lift and hook the faceplate over the spacers, and push the top of the faceplate back until it comes in contact with the base of the turn button. To secure the faceplate simply turn the head of the turn button to the horizontal position. (Fig. 47).
FIGURE 47
NOTE: A 1/4” gap must be maintained between the front and
all finishing material due to regular removal.
