FIGURE 30
SCREWS
BAFFLE PLATE
FIGURE 31
RESTRICTOR
PLATE
1.Remove the front and the door from the stove.
2.Remove the screws securing the baffle plate. Figure 31. Note: The baffle rests on two screws that are attached to the back of the firebox.
3.Using the screws supplied, attach the restrictor plate as show in Figure 31.
4.Replace the baffle.
MOBILE HOME INSTALLATION
This appliance is certified to be installed as an OEM (Origi- nal Equipment Manufacturer) installation in a manufactured home or mobile home and must be installed in accordance with the manufacturer’s instructions and the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home Standard, CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas indicated on the rating plate. A conversion kit is supplied with the mobile home appliance.
This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. The stove is equipped with two 1/4" diameter holes located in the front left and right corners of the base. For mobile home installa- tions, the stove must be fastened in place. Use #10 hex head screws, inserted through the holes in the base to secure. Always turn off the pilot and the fuel suuply at the source, prior to moving the mobile home. After moving the mobile home and prior to lighting the stove, ensure that the logs are positioned correctly.
This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile) home, where not prohibited by local codes.
This stove is only for use with the type of gas indicated on the rating plate. This stove is not convertible for use with other gases, unless a certified kit is used.
Conversion Kits
The mobile home appliance is field convertible between Natural Gas (NG) and Propane (LP).
To convert from one gas to another consult your Napoleon® dealer/distributor.
19
GAS INSTALLATION
Proceed once the vent installation is complete.
1.Move the stove into position and secure to the floor through the 1/4" holes located at either side of the base.
2.The stove is designed to accept 3/8" gas supply line. The stove is equipped with a 3/8" manual
3.Connect the gas supply in accordance to local codes. In the absence thereof, install according to the National Installation Code.
4.When flexing any gas line, support the gas valve so that the lines are not bent or kinked.
5.Check for gas leaks by brushing on a soap and water solution.
DO NOT USE OPEN FLAME.
Purge all gas lines with the glass door of the stove re- moved. Assure that a continuous gas flow is at the burner before
A | B | Manual |
|
| |
|
|
Shown
in “OFF” position.
FIGURE 32
Supply pressure can be checked by turning screw (A)
Manifold pressure can be checked the same as above using screw (B). Gauge should read 3.5” water column for natural gas or 10” water column for propane. Check that main burner is operating on “HI”.
AFTER TAKING PRESSURE READINGS, TIGHTEN SCREWS FIRMLY TO SEAL. DO NOT OVERTORQUE. LEAK TEST
