23
SWITCH FUNCTIONS
MAIN |
|
| NIGHT |
|
|
| FAN | ||||
BURNER |
|
| LIGHTTM |
|
|
| |||||
SWITCH |
|
| SWITCH |
|
| CONTROL | |||||
|
| ||||||||||
|
|
|
|
|
|
|
|
| OPTION |
| |
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FIGURE 44
TOP VIEW
MAIN BURNER SWITCH
This switch turns the Main Burner on and off.
NIGHT LIGHTTM SWITCH
This switch turns the Night LightTM on and off.
FAN CONTROL OPTION
If installed this switch will turn on and off the power to the blower and control the fan speed. There is also a thermally activated switch that will only let the blower come on once the unit has reached a comfortable temperature.
LOG PLACEMENT
In order to assemble the log set, the glass door must be removed, see Glass Door Installation and Removal in the FINISHING section of this manual.
FIGURE | BRACKET |
1.Place the rear log as shown, ensuring the holes on the underside are placed onto the 2 pins of the log support.
2.Place the left log as shown, ensuring the hole on the underside is placed onto the burner pin. This will rest on the left side of the rear log.
3.Place the center log as shown, ensuring the holes on the underside are placed onto the two center pins.
4.Place the hole in the underside of the right log onto the locating pin, on the burner base and rests against the rear log as shown.
5.
CHARCOAL EMBERS
Randomly place the charcoal embers along the front and sides of the burner in a realistic manner. Fine dust found in the bottom of the bag should not be used.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to be placed on the burner ports.
GLOWING EMBERS
Tear the embers into pieces and place along the burner ports covering all of the burner. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PhazerTM logs glow when exposed to direct flame. Use only certified "glowing embers" and PhazerTM logs available from your Napoleon® dealer.
