Napoleon Fireplaces GDS26P, GDS26N TABLE of CONTENTS, Retain This Manual For Future Reference

2

TABLE of CONTENTS

PG 3-5 INTRODUCTION		21	BLOWER INSTALLATION
	Warranty	21	NIGHT LIGHTTM REPLACEMENT
	General Instructions	22-23	FINISHING
	General Information
	Care of Glass and Plated Parts		Glass Door Installation and Removal
	Dimensions		Logo Placement
5-15	VENTING
			Glass Door Replacement
	Venting Lengths and Air Terminal Locations		Switch Functions
	Vent Installations		Log Placement
	Typical Vent Installations
		24	WIRING DIAGRAM
	Special Vent Installations
	Minimum Air Terminal Location Clearances	25	OPERATION / MAINTENANCE
	Venting Application Flow Chart		Operating Instructions
	Venting Specifications
			Maintenance
	Vertical Through Existing Chimney
	Rear Exit Conversion	26	ADJUSTMENTS
16-20	INSTALLATION		Pilot Injector and Orifice Replacement
	Wall and Ceiling Protection		Flame Adjustment and Characteristics
	Horizontal Installation
			Venturi Adjustment
	Vertical Installation
		27-28	REPLACEMENTS
	Stove Vent Connection
	Horizontal Venting Installation		Ordering Replacement Parts
	Vertical Venting Installation		Replacement Parts
	Mobile Home Installation
			Terminal Kits
	Gas Installation
			Accessories
	Minimum Clearances to Combustibles
	Minimum Mantel, Shelf or Ceiling Clearances	29-30	TROUBLE SHOOTING GUIDE
		31	SERVICE HISTORY
		32	NOTES

RETAIN THIS MANUAL FOR FUTURE REFERENCE

!WARNING

•Do not burn wood or other materials in this stove.

•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the stove.

•Clothing or other flammable material should not be placed on or near the stove.

•Due to high temperatures, the stove should be located out of traffic and away from furniture and draperies.

•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

•Even after the stove is out, the glass and/or screen will remain hot for an extended period of time.

•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.

•Any safety screen or guard removed for servicing must be replaced prior to operating the stove.

•It is imperative that the control compartments, burners and circulating blower and its passageway in the stove and venting system are kept clean. The stove and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The stove area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.

•Under no circumstances should this stove be modified.

•This stove must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.

•Do not use this stove if any part has been under water. Immediately call a qualified service technician to inspect the stove and to replace any part of the control system and any gas control which has been under water.

•Do not operate the stove with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

•Do not strike or slam shut the stove glass door.

•This stove uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

•Pressure relief doors must be kept closed while the stove is operating to prevent exhaust fumes containing carbon monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.

•Only doors / optional fronts certified with the unit are to be installed on the appliance.

W415-0607 / A / 01.18.08 NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.