10 STOVE VENT CONNECTION
1.Attach the adjustable pipe to the last section of rigid piping. Secure with screws and seal.
2.Install the 4" aluminium flexible liner to the stove. Se- cure with 3 screws and flat washers. Seal the joint and screw holes using the high temperature sealant provided.
3.Run a bead of high temperature sealant around the inside of the air intake collar. Pull the adjustable pipe a minimum 2" into the air intake collar.
Ensure that the sealant is not visible on the exte- rior pipes once installation is completed. An op- tional decorative brass band is available for this use. (Standard with a GD175 kit). In the event that the venting must be disassembled, care must be taken to reseal the venting.
FIGURE 21
#8x1/2"
SELF DRILLING SCREWS
2" OVERLAP
ON/OFF
SWITCH
VARIABLE
COMBUSTION AIRSPEED SWITCH COVER PLATES
& GASKETS
MOBILE HOME INSTALLATION
In Canada, mobile home installation may be vented hori- zontally or vertically. In the United States, it may only be installed vertically. See "Vertical Venting" or "Horizontal Air Terminal Installation" for installation.
The fireplace is equipped with two 5/16" diameter holes located near each corner of the base. For mobile home installations, the fireplace must be fastened in place. Use #10 screws, inserted through the holes in the base to se- cure. It is recommended that the fireplace be secured in all installations.
8"
11½"