3-38 Configuring Your System
Submenu item Parameter Description
Sync Transfer Rate
(MB/Sec)
[160] 20.0
80.0 16.0
53.4 13.4
40.0 10.0
32.0 ASYN
26.8
Select [160] as a recommended.
You may need to change the value
depending on your optional device.
Refer to the manual that comes with your
optional device.
Initiate Wide
Negotiation
[Yes]
No
Select "Yes" if your SCSI device supports the
Wide SCSI interface. Select "No" if not.
Enable Disconnection [Yes]
No
Select "Yes".
Send Start Unit
Command
[Yes]
No
Select "Yes" to send the command to the
hard disk. Otherwise select "No".
Enable Write Back
Cache
Yes
No
[N/C]
Select "N/C".
BIOS Multiple LUN
Support
Yes
[No]
Select "No".
Include in BIOS Scan [Yes]
No
Select "Yes".
[ ]: Factory-set
! Advanced Configuration Options
Move the cursor onto "Advanced Configuration Options" and press Enter to display thefollowing submenu.Advanced Configuration Options
Reset SCSI Bus at IC Initialization................................................................. Enabled
Display <Ctrl><A> Message During BIOS Initialization .................................. Enabled
Extended BIOS Translation for DOS Driver > 1 GByte ................................... Enabled
Verbose/Silent Mode...................................................................................... Verbose
Options Listed Below Have NO EFFECT if MULTI LUN Support Is
Disabled
Host Adapter BIOS ........................................................................................ Enabled
Domain Validation......................................................................................... Enabled
Support Removable Disks Under BIOS as Fixed Disks .................................. Disabled
BIOS Support for Bootable CD-ROM.............................................................. Enabled
BIOS Support for Int13 Extensions................................................................ Enabled