NEC 5800 Setting Up Your System 2-17, NOTE: Make sure of the cable you are going to connect. The "100BASE-

Setting Up Your System 2-17
NOTE: Make sure of the cable you are going to connect. The "100BASE-
TX/10BASE-T connector" and the "serial port 2 connector" of this server
have the same shape. Be careful not to connect a cable to a wrong
connector. To prevent wrong connection, write "LAN port" on a tag and
put the tag to the connector of the LAN cable that is to be connected to
this server.
*1 Windows NT 4.0 needs the compliant driver. Any USB keyboard and mouse are not supported.
*2 A leased line cannot be connected directly to this connector.
The console of a management PC can be connected to only serial por t 2. (BIOS setting required)
This connector is capped for preventing incorrect connection in the st andard status.
*3 Use the provided branch cable.
*4 Connect the power cord to a circuit breaker of 15 A or less.
Device with
the serial
interface
(e.g.,
Management
PC)*2
USB device
*1
Keyboard Mouse
Display unit Hub
(multiport repeater)
USB device
*1
USB device
*1
FRONT
REAR
Device with the
serial interface*2
Device with the
SCSI interface
*3
Finally connect the
provided power cord to
the receptacle. *4
If connecting the server
to UPS, see the
explanation below.