Upgrading Your System 7-27
9. Insert a standard screwdriver into the bracket of the wire clip, and engage the wire clip
with the socket.
10. Make sure that the heat sink is level.
NOTES:
! If the heat sink is not level, remove it, and then install it again. The
following probably causes the heat sink not to be level:
– The heat sink is not positioned correctly.
– The wire clip is not engaged correctly.
! Do not move the secured heat sink.
11. Install the components you removed previously.
12. Power on the server, start the SETUP utility, and select [Main] → [Processor Settings] →
[Processor Retest] → [Enabled].
13. Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive, and start the system
through EXPRESSBUILDER.
For details, see Chapter 6.
14. Diagnose the system.
For details, see EXPRESSBUILDER User's Guide on the EXPRESSBUILDER CD.