Troubleshooting 6-27
Problems with Configuration Diskette Creator
<Common to Windows 2000/Windows NT 4.0>
The bit map of the Configuration Diskette Creator window is not displayed
correctly during setting of setup information.
! If the specified number of colors is fewer than 256 in the display setting, the bit map is
not displayed correctly, but the setup information can be displayed correctly.
<Windows 2000>
The Point to Point tunneling protocol cannot be set.
! The protocol is not supported at present. After installation, set the protocol through
Control Panel. In this case, rebooting is not necessary.
The details of a network adapter cannot be set.
! Configuration Diskette Creator is unable to set the details of network adapters. Start
Windows 2000, and set the details through Control Panel.
<Windows NT 4.0>
Resolution cannot be set during setting of setup information.
! When completing installation of Windows NT 4.0, set resolution through Control Panel.
More than one network board is connected during setting of setup information,
but TCP/IP cannot be set for each network.
! Perform the installation procedure during DHCP setting. To create a temporary IP
configuration, perform the installation procedure during DHCP setting, and then set
TCP/IP again through Control Panel.