When Used with Two or More Switchers (100 Inputs)
Up to 100 inputs can be accepted using the NEC
How to make connections:
1Connect the REMOTE 1 terminal of the master Switcher to the REMOTE 1 of the projector using the optional control cable
2Next connect the REMOTE 2 terminal of the master Switcher to the REMOTE 1 terminal of the first slave Switcher using the same optional control cable as mentioned above. Third, connect the REMOTE 2 termi- nal of the first slave to the REMOTE 1 of the second slave, and the REMOTE 2 terminal of the second slave to the REMOTE 1 terminal of the third slave (— and the REMOTE 2 of the ninth slave to the REMOTE 1 of the tenth slave). Connect all the Switchers with optional control cables.
•Select [Advanced Menu] → [Projector Options] → [Switcher Control] → [SW2 Level]. See page
•Refer to the user’s manual accompanying the Switcher.
•Cables mentioned are not included with the projector.
NOTE:
•Be sure to set all the slide switches (S8603) of the Switcher to
•Set the DIP switch S8601 of the Switcher.
| To RS232C |
To REMOTE 1 | |
To REMOTE 1 | To REMOTE 2 |
| To Slot 1 |
| To Slot 2 |
Personal
Computer
To REMOTE 1
To REMOTE 2
To REMOTE 1
To REMOTE 2
To REMOTE 1
Slave 1
Slave 2
To Slot
To Slot
To Slot 10
To REMOTE 2
To REMOTE 1
Slave 10
To Slot
NOTE: The optional remote control
To use the projector with the Switcher
*When connecting with the VIDEO INPUT MODULE
NOTE: While in the Switcher Control mode, a video standard is selected at the projector.
*If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher
In that case, first remove the QUAD DECODER from the Switcher
For more details, contact your dealer.
E – 29