Connecting to a Single Workstation
You can connect a workstation to your GT1150 projector. To do so:
1.Turn off the power to your projector and workstation.
2.Use a BNC x 5 cable to connect your workstation and the RGB 1 connectors on your projector.
3.Turn on the projector and a workstation.
To RGBHV output To RGBHV output
Signal distribution
To RGBHV input
To analog RGB output
BNC 5 cable
| DVI | L/MONO | R |
|
| L/MONO | R |
| MONITOR OUT | RGB 2 |
|
RGB 1 | R/Cr | G/Y | B/Cb |
To analog
RGB input
Workstation
NOTE: All cables mentioned above are sold separately.
Information for Reducing Radiation of Electromagnetic Waves
To reduce unnecessary radiation of electromagnetic waves, use the supplied ferrite core,
VIDEO 1 |
| H/HV | V |
L/MONO |
| L/MONO | R |
VIDEO 2 |
|
|
|
L/MONO | R | L/MONO | R |
| AUDIO OUT | ||
Installation Instructions
1.Open and attach the ferrite core to a sig- nal cable as close as possible to the end that goes to the projector.
*Push the catch to open the ferrite core.
3.Fix the supplied band to the cable as a stopper.
*Pull the end of the band to tighten it. Cut off the surplus of the band.
Band
2. Close the ferrite core tightly.
NOTE: Be sure to use the ferrite core at the end of the signal cable.
To a connected equipment
To RGB2 input of GT1150
E – 27
