System configuration
Command: /cfg/sys
[System Menu] |
|
syslog | - Syslog Menu |
sshd | - SSH Server Menu |
radius | - RADIUS Authentication Menu |
tacacs+ | - TACACS+ Authentication Menu |
ntp | - NTP Server Menu |
ssnmp | - System SNMP Menu |
access | - System Access Menu |
watchdog | - Watchdog Menu |
date | - Set system date |
time | - Set system time |
timezone | - Set system timezone (daylight savings) |
olddst | - Set system DST for US |
dlight | - Set system daylight savings |
idle | - Set timeout for idle CLI sessions |
notice | - Set login notice |
bannr | - Set login banner |
hprompt | - Enable/disable display hostname (sysName) in CLI prompt |
dhcp | - Enable/disable use of DHCP on Mgmt interface |
rstctrl | - Enable/disable System reset on panic |
cur | - Display current |
This menu provides configuration of switch management parameters such as user and administrator privilege mode passwords,
The following table describes the System Configuration Menu options.
Table 58 System Configuration Menu options
Command | Usage |
|
syslog | Displays the Syslog Menu. |
|
sshd | Displays the SSH Server Menu. |
|
radius | Displays the RADIUS Authentication Menu. |
|
tacacs+ | Displays the TACACS+ Authentication Menu. |
|
ntp | Displays the Network Time Protocol (NTP) Server Menu. |
|
ssnmp | Displays the System SNMP Menu. |
|
access | Displays the System Access Menu. |
|
watchdog | Displays the Watchdog Menu. |
|
date | Prompts the user for the system date. |
|
time | Configures the system time using a |
|
timezone | Configures the time zone where the switch resides. You are | |
| prompted to select your location (continent, country, region) by the | |
| timezone wizard. Once a region is selected, the switch updates the | |
| time to reflect local changes to Daylight Savings Time, etc. |
|
dlight | Disables or enables daylight saving time in the system clock. When | |
| enabled, the switch will add an extra hour to the system clock so | |
| that it is consistent with the local clock. By default, this option is | |
| disabled. |
|
idle | Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The | |
| default is 5 minutes. | |
| This setting affects both the console port and Telnet port. |
|
notice | Displays login notice immediately before the “Enter password:” | |
line> | prompt. This notice can contain up to 1024 characters and new | |
| lines. |
|
bannr | Configures a login banner of up to 80 characters. When a user or | |
| administrator logs into the switch, the login banner is displayed. It is | |
| also displayed as part of the output from the /info/sys/gen | |
| command. |
|
hprompt disableenable | Enables or disables displaying of the host name (system | |
| administrator’s name) in the command line interface. |
|
dhcp | Dynamic Host Control Protocol for setting the management IP | |
| address on interface 256 is enabled.You can not configure this | |
| option to be disabled. |
|
rstctrl | Enables or disables reset when the panic occurs on the switch | |
| software. The default value is enabled. |
|
| Command Line Interface 62 | |