Resetting the switch

You can reset the switch to make your software image file and configuration block changes occur.

Resetting the switch causes the Spanning Tree Protocol to restart. This process can be lengthy, depending on the topology of your network.

To reset the switch, at the Boot Options# prompt, enter:

>> Boot Options# reset

You are prompted to confirm your request.

Current switch software information

To display the current switch software information, enter the following.

>> Boot Options# cur

Currently set to boot software image2, factory default config block. Current FLASH software:

image1: version 1.2.0, downloaded 0:15:51 Mon Jan 2, 2006 NormalPanel

image2: version 1.0.0, downloaded 1:32:08 Sun Jan 8, 2006 SmartPanel

boot kernel: version 1.2.0

Use this command to display the image running on the switch, the Configuration block which the switch runs after booted, and the switch software stored in image1 and image2.

When NormalPanel is displayed in the software information, the software for conventional Layer2 switch mode is stored in the image. When SmartPanel is displayed, the software for SmartPanel mode is stored in the image.

Command Line Interface 85