Group configuration

Command: /cfg/group <1-5>

[Group 1 Menu]

 

addport

- Add ports to the group

remport

- Remove ports from the group

addvlan

- Add non-default (tagged) VLANs to the group

remvlan

- Remove non-default (tagged) VLANs from the group

pvid

- Set default port VLAN id for the group

igmp

- Enable/Disable IGMP Snooping for the group

failover

- Enable/Disable Failover for the group

limit

- Number of External Links to trigger failover

lacp

- Enable/Disable LACP for the group

cur

- Display current group configuration

 

 

Use these menu options to set the Port Group. There are five Port Groups. Set the ports, which Port Group 1-5 do not contain, to Spare Ports Group.

The following table describes the Port Group Configuration menu options.

Table 82 Port Group Configuration menu options

Command

Description

addport <port number>

Adds the specified port to the Port Group.

remport <port number>

Removes the specified port from the Port Group.

addvlan <1-4094>

Adds the non-default (tagged) VLAN to the Port Group.

remvlan <1-4094>

Removes the non-default (tagged) VLAN from the Port Group.

pvid <1-4094>

Sets default port VLAN ID (PVID) to the Port Group. The default is automatically

 

assigned when the Group is used.

igmp disableenable

Enables or disables IGMP snooping for the Port Group.

failover

Enables or disables Failover for the Port Group. The default is enabled. When it is

disableenable

enabled and the number of external links is the value of the limit or fewer, the switch

 

disables the internal server blade port of the Port Group.

limit <0-4>

Sets the number of external links to trigger failover. The default is 0. The failover limit

 

lets you specify the minimum number of operational links required within the failover

 

trigger before the trigger initiates a failover event. For example, if the limit is four, a

 

failover event occurs when the number of operational links in the trigger is four or

 

fewer. When you set the limit to zero, the SmartPanel triggers a failover event only

 

when no links in the trigger are operational.

lacp disableenable

Enables or disables LACP for the Port Group. The default is disabled. When

 

disabled, the external ports of the Port Group are configured as a static trunk group.

 

When enabled, they are configured as a LACP trunk group.

cur

Displays the current Ports Group configuration.

 

 

 

NOTE: A Port Group must contain at least one external port (20-24) and one internal server blade port (1- 16).

See the “Port Group Mapping” section in the “Browser-based interface” chapter for information.

Command Line Interface 79