Connecting Your PC or Macintosh Computer

Connecting your PC or Macintosh computer to your MultiSync XV29 Plus will enable you to display your computer's screen image. All of these following display standards are supported:

VGA 6402480 for graphics, VGA 6402400 for graphics, VGA 6402350 for graphics, VGA 7202400 for text, VGA 7202350 for text, SuperVGA 8002600, and XGA 10242768 standards above 60 Hz such as Macintosh at 6402480, 8322624 and 10242768.

To connect to a PC, Macintosh or computer equipped with a XGA/ SuperVGA/VGA adapter or compatible graphics adapter, simply:

1.Turn off the power to your monitor and computer.

2.If your PC does not support Super XGA/VGA/VGA you will need to install an XGA/SuperVGA/VGA graphics board. Consult your computer's owner's manual for your XGA/SuperVGA/VGA configuration. If you need to install a new board, see the manual that comes with your new graphics board for installation instructions.

17

3.Use the supplied RGB cable to connect your computer to the monitor. For Macintosh, use a commercially avalable adapter between the D-Sub mini 15-pin connector of the supplied RGB cable and the D-Sub 15-pin connector of your Macintosh.

4.Turn on the monitor and the computer.

NOTE: Refer to your computer's owner's manual for more information about your computer's video output requirements and any special identification or configuring your monitor's image and monitor may require.

Connecting Your VCR or Laser Disc Player

Using a common RCA cable and RCA audio cables (not provided) to connect your VCR or laser disc player to your MultiSync XV29 Plus monitor. To make these connections, simply:

1.Turn off the power to your monitor and VCR or laser disc player.

2.Connect one end of your RCA video cable to the video output connector on the back of your VCR or laser disc player, connect the other end to the VIDEO 1 or 2 input terminal(RCA-type) of the monitor. Use standard RCA audio patch cords to connect the audio from your VCR or laser disc player to your monitor (if your VCR or laser disc player has this capability). Be careful to keep your right and left channel connections correct for stereo sound.

3.Turn on the monitor and the VCR or laser disc player.

NOTE: Refer to your VCR or laser disc player owner's manual for more information about your equipment's video output requirements.

NOTE: S-VIDEO IN terminals will take preference over VIDEO IN terminals when a component is connected to each terminal and VIDEO 1 or 2 selected.

Connecting Your Document Camera

You can connect your MultiSync XV29 Plus monitor to a document camera. To do so, simply:

1.Turn off the power to your monitor and document camera.

2.Use a standard video cable to connect your document camera to the VIDEO 1 or 2 input terminal(RCA-type) of the monitor.

3.Turn on the monitor and the document camera.

NOTE: Refer to your document camera's owner's manual for more information about your camera's video output requirements .

18