Nesco Convection Roaster Oven manual Before Using For The First Time, Installing The Motor And Fan

BEFORE USING FOR THE FIRST TIME

1.Unpack your NESCO Roaster Oven completely. Remove the Cookwell, all packing materials and information labels. Place the Roaster Oven in a well-ventilated area and on a heat resistant surface. Plug the cord into a 120-volt AC outlet, set the temperature to its maximum setting. Operate the Roaster Oven empty (without the Cookwell and Cover) for about 60 minutes, or until any odor or smoke disappears. Some odor and smoke is a normal part of “curing” the heating element, and will not occur while cooking. When “curing” is completed, turn the temperature control to the lowest setting, unplug the cord from electrical outlet and allow unit to cool.

2.Wash the Cover, Cookwell and Rack in warm, sudsy water. Rinse and Dry. See “Care and Cleaning” section for complete instructions.

INSTALLING THE MOTOR AND FAN

1.Remove the fan by lifting tabs on Fan. Then insert Motor Housing into the Handle, align hole in Cover with shaft of Motor, and push on Motor Housing until it “locks” onto the Handle. (See Fig. 1)

2.To attach the Fan to the Motor, align flat edge of spring clip with flat surface on motor shaft and gently press the fan onto the motor shaft until the fan can no longer be pushed onto the shaft. Note: Do not press or pull on the fan blades while handling. (See Fig 2)

3.Reverse the steps to remove Fan and Motor assembly when cleaning the Cover is necessary.

Fig. 1

Fig.2