DELAY TIME SETTING:
1.Press “DELAY TIME” button. The display will show “0.5” (equals 30 minutes) and the indicator light will be lit. Repeat pressing ‘DELAY TIME’ until desired amount of delay time is displayed. Total delay time is 8 hours.
2.Select the desired cooking mode (HIGH, LOW, STEAM, etc.) and time by pressing the appropriate button(s).
3.Press the ‘START/STOP’ button and the delay time indicator light will turn on. Your appliance will begin desired cooking after the delay time has elapsed. The time delay indicator light will turn off.
CLEANING YOUR DIGITAL COOKER
1.Unplug cord from the wall outlet, then the appliance and let the unit cool before cleaning.
2.DO NOT wash any parts of your appliance in a dishwasher. Use warm soapy water, rinse and dry. Always clean after each use or if it has not been used for an extended period of time.
3.Wipe base with a clean damp cloth. NEVER submerge the base in water or other liquid. Wipe the inside of base as necessary to remove any food product.
4.If the condensation reservoir contains visible moisture, remove by pulling down. Wash in warm soapy water. Rinse and dry. Attach to base by pushing up to lock into place.
5.Turn the lid upside down, grasp the rubber gasket on either side and pull up. Wash gasket in warm soapy water. Rinse and dry thoroughly. Insert the rubber gasket by pushing it down inside the edge of the lid, making sure the ‘v’ groove of the gasket is centered around the wire ring on the lid. NOTE: If the rubber gasket is not positioned properly the appliance will not function normally.
6.In order to maintain good performance of your appliance, the bottom of the removable cooking pot should be cleaned after each use. Wipe with a soft damp cloth and dry before using.
7.Never use abrasive cleaners or scouring pads to clean any parts of this appliance, as they will make fine scratches in the surface, especially on the polished surfaces.
8.Store your appliance with the lid resting upside down on the removable cooking pot. This will protect the valves, knobs and pressure regulator on the top of the lid. If the appliance is stored with the lid sealed, stale odors may form on the inside.
Cleaning the Pressure Regulator Knob
Check to make sure the pressure regulator knob and floating valve are in good working order before each use. To clean, please follow the instructions below:
1.After the unit has cooled, remove the lid.
2.Press down and turn the pressure regulator knob clockwise past the SEAL setting and carefully lift and remove.
3.Turn the lid upside down and set on a tabletop. Pull out the filter by firmly grasping with a soft cloth lifting upwards. Using a small brush, check and remove any food particles that may be lodged inside the filter and the floating valve. Push filter back in place.
4.Replace the pressure regulator knob by lining the notches up to the inside wall of the pressure regulator chamber in the lid, then press down and turn clockwise to latch.
English
9
