NETGEAR manual Attaching Mounting Brackets to the Model FS518T Switch

FS518T.Manual.FINAL 5/19/00 12:55 PM Page 28

4.Hold the switch with the mounting holes in the brackets aligned with the holes in the rack.

8945FB

Figure 4-1. Attaching Mounting Brackets to the Model FS518T Switch

5.Insert two pan-head screws with nylon washers through each bracket and into the rack.

6.Using a #2 Phillips screwdriver, tighten the screws to secure the switch to the rack.

For proper ventilation, make sure that the switch has at least 2 inches of space on each side and 5 inches of space at the back. It is very important that the fans located in the rear panel are not blocked.

Caution: Restricted airflow could cause overheating of the components.

To connect additional switches or other devices, refer to “Connecting Devices to the Switch.”

installation 4-4