NETGEAR RH348 manual 71

Reference Guide for the Model RT328 and Model RH348 ISDN Routers

Table 6-1. Fields in Menu 13 - Default Dial-in Setup (continued)

Field Description

Multiple Link Options:

Max Trans RateEnter the maximum data transfer rate between your router and the remote dial-in user in this field. The unit is in Kbps. The two options for this field are:

•64—At most, one B channel is used.

•128—A maximum of two channels can be used (default).

When the router calls back to the remote dial-in user, the maximum data transfer rate is always 64.

Callback Budget Management:
Allocated Budget (min)	This field sets a budget callback time for all the remote dial-in users.
	The default for this field is 0 for no budget control.
Period (hr)	This field sets the time interval to reset the above callback budget control.
IP Address Supplied By:
Dial-in User	If this field is set to Yes, the router allows a remote host to specify its own
	IP address. If this field is set to No, the remote host uses the IP address
	assigned by the router from the IP pool. The default is Yes.
IP Pool	If this field is set to Yes, the router provides the remote host with an IP
	address from the pool. This field is required if Dial-In IP Address Supplied
	By: Dial-in User is set to No. You can configure this field even if Dial-in
	User is set to Yes, in which case the router accepts the IP address if the
	remote peer specifies one; otherwise, an IP address is assigned from the
	pool. The default is No. Choose from the following options to set the IP
	address and the IP count:
	• IP Start Addr—This field is active only if you selected Yes in the Dial-In
	IP Address Supplied By: IP Pool field. The IP pool contains contiguous
	IP addresses, and this field specifies the first one in the pool.
	• IP Count (1,2)—In this field, enter the number (1 or 2) of the addresses
	in the IP pool. For example, if the starting address is 192.168.135.5 and
	the count is 2, then the pool has 192.168.135.5 and 192.168.135.6.

Dial-In Configuration 6-3