|
| Reference Guide for the Model RT328 and Model RH348 ISDN Routers | |
|
|
| |
Table | Menu 11.1 Remote Node Profile Fields (continued) | ||
|
|
| |
Field |
| Description | |
|
| ||
Pri(mary) Phone | Both the Primary and Secondary Phone numbers refer to the number that the | ||
Number and |
| router dials to connect to the remote node. The router calls the remote node using | |
Sec(ondary) |
| the Primary Phone number first. If the Primary Phone number is busy or does not | |
Phone Number | answer, the router calls the Secondary Phone number if available. Note that the | ||
|
| secondary number is not necessarily the number your router will dial to add | |
|
| additional bandwidth for a Multilink call. If the called router supports BACP, that | |
|
| router will provide the dial number for a second call. In North America, NETGEAR | |
|
| recommends that you enter 1 and the area code with the number, even if it is a | |
|
| local call. Otherwise, in some areas, the call is placed as a 56K call. | |
|
| ||
Edit PPP Options | To edit the PPP options for this remote node, move the cursor to this field, use the | ||
|
| space bar to select Yes, and press [Enter] to display Menu 11.2 - Remote Node |
PPPOptions. For more information about configuring PPP options, see “Editing PPP Options” on page
Rem IP Addr | This field is required on all remote nodes except the ISP node. Enter the IP address |
| of the router at the remote site. A static route will be created to the network address |
| of that router. Note that if the remote network uses a netmask other than the |
| standard class netmask, you must enter the netmask in the Edit IP Options |
| submenu. |
|
|
Edit IP Options | This field edits the parameters of the TCP/IP protocol. Select Yes and press [Enter] |
| to display Menu 11.3 - Remote Node Network Layer Options. For more information |
| about this screen, refer to Chapter 7, “TCP/IP Configuration.” |
|
|
Telco Options: |
|
Transfer Rate | When establishing a call in North America, your router specifies a data rate and the |
| type of call based on this field. Three options are available for this field: |
| • |
| • |
| • |
| call. Some phone companies in North America charge less if calls are made |
| using DOVBS. |
Allocated | This field sets a budget on outgoing call time for the remote node. The default for |
Budget (min) | this field is 0 for no budget control. |
Period (hr) | This field sets the time interval to reset the above outgoing call budget control. |
Remote Node Configuration |