9 | English |
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the
Power Indicator Is Not Lit
The power indicator should be lit whenever the
Fuse Replacement
If another electrical device works when plugged into the power outlet, but the power indicator still will not light when the
No Sound
Check the signal source to see if it is func- tioning properly. Make sure the cables from the signal source to the
Specifications
Continuous Power Output | 60 watts/channel |
Total Harmonic Distortion | < 0.03% at rated power, 1/2 power, or 1 watt |
Intermodulation Distortion (60 Hz : 7 kHz, 4:1) | < 0.03% at rated power, 1/2 power or 1 watt |
Frequency Response |
|
Phono Input | |
Line Level Inputs | |
Damping Factor | 150 |
Line Input Sensitivity / Impedance | 160 mV / 24 kOhms |
Line Input Overload | 5 V |
Phono (MM) Sensitivity / Impedance | 2.4mV /47 kohms |
Input (Phono) Overload | 170 mV |
Preamplifier Output / Impedance | 1V / 470 ohms |
Signal to Noise Ratio (IHF “A” weighted) | >95 dB |
Power Requirements |
|
USA: | 115 Volts, 60 Hz |
EC: | 230 Volts, 50 Hz |
Power Consumption | 300 Watts |
Dimensions (W x H x D) | 430 x 92 x 355 mm |
| 17 x 55/8 x 14 inches |
Front Panel Height | 80mm / 3 3/16 inches |
Weight (net) | 7.8 kg, 17.2 lbs. |
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.