Reference Guide for the Model RT328 and Model RH348 ISDN Routers

Remote Node Setup

See Chapter 5, “Remote Node Configuration,” for information about using the protocol- independent parameters on Menu 11.1 - Remote Node Profile. Use the fields described in Table 7-1 to set the protocol-dependent parameters.

Note: If you are configuring the router to receive an incoming call, you must also set the default dial-in parameters in Menu 13 (see Chapter 6).

Table 7-1.

Fields in Menu 11.1 - Remote Node Profile Fields

 

 

 

Field

 

Description

 

 

 

Rem IP Address

 

Enter the IP address of the router at the remote site. If the remote router uses a

 

 

different IP address than the one entered here, the call will be terminated. A static

 

 

route will be created to the network address of the remote router. Note that if the

 

 

remote network uses a netmask other than the standard class netmask, you must

 

 

enter the netmask in the Edit IP Options submenu.

 

 

 

Edit IP

 

Press the space bar to change this field to Yes and press [Enter] to display the Menu

 

 

11.3 - Remote Node Network Layer Options menu.

 

 

 

To set the protocol-dependent parameters:

1.Select Yes in the Edit IP field of Submenu 11.1 - Remote Node Profile.

2.Press [Enter] to display Menu 11.3 - Remote Node Network Layer Options.

3.Edit the options described in Table 7-2.

4.Press [Enter] at the Press ENTER to Confirm... prompt to confirm your selections and return to the previous menu.

Press [Esc] at any time to cancel your selections.

5.Continue to the end of Menu 11.1 and press [Enter] to save the selections you made in Menu 11.3.

7-2

TCP/IP Configuration