![](/images/new-backgrounds/1263331/26333161x1.webp)
Vehicle Installation
NOTE: Each antenna has specific installation instructions. Please refer to the antenna installation instructions for specific requirements and details.
Mount GPS Antenna (optional)
The iR1200
The following table contains the steps for mounting a GPS antenna.
1Use an antenna suitable for the GPS of frequency 1575 MHz with an MCX connector and matched for
2Position the antenna where it has a direct
3Mount the antenna according to the manufacturer’s specifications or instructions.
NOTE: Because of the operating frequencies involved with the GPS signal, splicing or using adapters to extend the length of the antenna coaxial cable is not recommended and will likely prevent the system from operating properly. We recommend that a single length of coax without splices or adapters be used.
Route and Connect Cables
Approved Cable
The following DC power cable must be used (sold separately, see Accessories Table for ordering information).
5100-C5-RFM – Vehicle Power Harness
23 |