Nextel comm IR1200 manual Connect Antenna Cables, Connect Data Cables

Stationary Installation

Connect Antenna Cables

The following table describes the steps for connecting antenna cables to the modem (use only an approved antenna – see list of Approved Antennas on page 31):

1Insert the male end of the modem antenna cable to the connector labeled MODEM ANT on the modem.

2Insert the male end of the GPS antenna (optional) cable to the connector labeled GPS ANT on the modem.

Connect Data Cables

The iR1200 modem can be connected to the host DTE equipment using a standard “straight through” 9-pin male to a 9-pin female serial cable.

The following step describes how to connect the data cable:

Connect the 9-pin male end of the cable to the iR1200 communication connector and the 9 pin female end of the cable to the data terminal equipment (DTE).

RFM-4200-5015 Rev1 35