• GPS Adapter Cord MC-35(0 233): This 35 cm (1 ft 2 in.) cable connects the camera to older GARMIN eTrex- and geko-series GPS units that conform to version 2.01 or 3.01 of the National Marine Electronics Association NMEA0183 data format. Only models that support PC interface cable connections are supported; the MC-35
can not be used to connect GPS units via USB. The units connect to the MC-35 using a cable with a D-sub
terminal
9-pin connector provided by the manufacturer of the
accessories
GPS device; see the MC-35 instruction manual for details. Before turning the camera on, set the GPS device to NMEA mode (4800 baud); for more information, see the documentation provided with the GPS device.
•Modulite Remote Control Set ML-3: Allows infrared remote control at ranges of up to 8 m (26 ft 3 in.).
HDMI Cable HC-E1: An HDMI cable with a type C connector
for connection to the camera and a type A connector for connection to HDMI devices.
•Filters intended for special-effects photography may interfere with autofocus or the electronic rangefinder.
•The D810 can not be used with linear polarizing filters. Use the C-PL or C-PLII circular polarizing filter instead.
•Use NC filters to protect the lens.
•To prevent ghosting, use of a filter is not recommended
Filters | when the subject is framed against a bright light, or |
| when a bright light source is in the frame. |
•Center-weighted metering is recommended with filters with exposure factors (filter factors) over 1× (Y44, Y48, Y52, O56, R60, X0, X1, C-PL, ND2S, ND4, ND4S, ND8, ND8S, ND400, A2, A12, B2, B8, B12). See the filter manual for details.
