Reference Section

The Setup Menu

BNotes About GPS

When positioning for the first time, when positioning was unable to be performed for about 2 hours, or after the battery was changed, it takes a few minutes to obtain the position information. After switching to the shooting application from another application such as the playback application, it takes a few seconds to obtain the position information.

Positions of the GPS satellites change constantly. You may not be able to determine the position or it may take some time depending on your location and the time. To use the GPS feature, use the camera in an open-air area with few obstacles in the sky. Signal receiving will be smoother if the GPS antenna (A1) is facing the sky.

If the camera needs to be turned off inside an airplane or hospital, set Use GPS satellites in Location & security in the Android™ platform setting menu (A91) to off.

The following locations which block or reflect signals may result in failed or inaccurate positioning.

-Inside buildings or underground

-Between high-rise buildings

-Under overpasses

-Inside tunnels

-Near high-voltage electrical power lines

-Between clusters of trees

-Underwater

Using a mobile phone of 1.5 GHz band near this camera may disrupt positioning.

When carrying this camera around while positioning, do not place it in a metal bag. Positioning cannot be performed if the camera is covered with metal materials.

When there is a significant difference in the signals from the GPS satellite, there could be a deviation of up to several hundred meters.

Be aware of your surroundings when positioning.

The shooting date and time that is displayed when playing back images is determined by the camera’s internal clock at the time of shooting. The camera does not display the time at which position information was obtained for an image.

Position information will be recorded on the first frame of images shot using continuous shooting mode.

The Geodetic system for this camera’s GPS function uses the WGS 84 (World Geodetic System 1984).

BNotes About Synchronize

The Synchronize function adjusts the date and time based on the time zone set in Date & time in the Android™ platform setting menu (A91). Check the time zone before using Synchronize.

The date and time set by the Synchronize function is not as accurate as that of radio clocks. If the time set by Synchronize is not accurate, set the time in Date & time in the Android™ platform setting menu (A91).

E64

Page 180
Image 180
Nikon 26358, 26356, S800c White, S800c Black manual E64