Nikon COOLPIXS1000PJ user manual Electronically Controlled Cameras, 157, Troubleshooting

Troubleshooting

Problem	Cause/Solution	A
Monitor turns off, and	Battery temperature is high. Turn off camera and allow	17
the power-on lamp	battery to cool down before resuming use. After the
blinks rapidly.	lamps blink for three minutes, the camera will turn off
	automatically. Pressing the power switch also turns off
	the camera.
Camera does not	• Battery of the remote control is exhausted.	7
respond to remote	• Point the remote control at the infrared receiver on	35,
control operation.	the front or rear on the camera at the distance within	138
	approximately 5 m (16 ft.).
	• When Smile timer is set to On in smart portrait	50
	mode, and the camera recognizes human faces,
	remote control operation is not available.
	• The shutter may not be released when attempting to	–
	use the remote control to take pictures of scenes
	exhibiting severe backlighting.

Electronically Controlled Cameras

In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the battery, then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon-authorized service representative. Note that disconnecting the power source as described above may result in the loss of any data not recorded to internal memory or the memory card at the time the problem occurred. Data already recorded will not be affected.

Shooting

Problem		Cause/Solution	A
No picture taken when shutter-	•	When camera is in playback mode, press the	10, 28
release button is pressed.	•	A button or the shutter-release button.
		When menus are displayed, press the d	12
	•	button.
		Battery is exhausted.	22
	•	When flash lamp blinks, flash is charging.	31

Technical Notes

157