Nikon S800c manual Tap OK on both screens, E22

Reference Section

Transferring Images to Your Smart Device

4Position the camera near the smart device while the Searching...

screen is displayed.

5 Wait for the camera to detect the smart device.
		Upload to smart device
	15:30
• If the “Activate Wi-Fi and select the camera SSID.” message		Simple setup
is displayed when you are using an iOS smart device, follow
the procedure below to configure the settings.
- Make sure the smart device’s Wi-Fi (wireless LAN)		Searching…
function is on. If the Wi-Fi (wireless LAN) function is off,
turn it on.

-In the network list displayed on the smart device when the smart device’s Wi-Fi (wireless LAN) function is turned on, select the network SSID that is displayed on the camera screen.

After the settings are complete, display the Connect to

S800c application screen again.

•When the camera detects the smart device, the authentication screen is displayed.

6 Confirm that the numbers on the camera screen
		Upload to smart device
	15:30
match those on the smart device screen.		Simple setup
• If the numbers match, proceed to the next step.
		Confirm that the number displayed by the
		smart device matches the 4-digit number
		displayed below.

OK

Cancel

7Tap OK on both screens.

•The simple setup complete screen is displayed. Tap OK to complete the settings.

•When using an iOS smart device, the Install Profile screen is displayed. The profile starts installing automatically. Wait until the installation is complete.

-If JavaScript is disabled, the settings cannot be completed. Enable JavaScript in the default browser application.

-If the profile installation is canceled before completion, perform the simple setup procedure again.

-If the settings are not completed properly, uninstall the profile and install it again.

E22