Nikon S800c manual Transferring Images from Camera to Smart Device, E23

Transferring Images to Your Smart Device

BNotes About Simple Setup

•The simple setup function is not able to connect the COOLPIX S800c to multiple smart devices. The simple setup function can connect the camera to only one smart device.

•When you use the simple setup function to configure a new connection to a smart device other than the one that was previously configured, the previous connection settings are overwritten with the new ones. To use the previous connection settings, perform the simple setup procedure again.

•To reconfigure the previous connection settings when using an iOS4.x smart device, uninstall the previously installed camera profile before performing the simple setup procedure again.

Transferring Images from Camera to Smart Device

1 Tap Start service on the camera screen.
	Upload to smart device
	15:30

Simple setup

Start service

2Tap Connect to camera on the smart device screen.

•The smart device initiates a connection with the camera using the settings you previously made, and the Searching... screen is displayed.

•If the “Activate Wi-Fi and select the camera SSID.” message is displayed when you are using an iOS smart device, follow the procedure below to configure the settings.

-Make sure the smart device’s Wi-Fi (wireless LAN) function is on. If the Wi-Fi (wireless LAN) function is off, turn it on.

15:30

Connect to S800c

Simple setup

Connect to camera

Reference Section

-In the network list displayed on the smart device when the

smart device’s Wi-Fi (wireless LAN) function is turned on, select the network SSID that is displayed on the camera screen.

After the settings are complete, display the Connect to S800c application screen again.

E23