Nikon Turning the SB-28on and off / Standby function, Turning power on and off

Turning the SB-28 on and off / Standby function

Turning power on and off

To turn the SB-28 on and off, depress and hold the = button for approx. 0.5 sec.

Standby function

If both the SB-28 and camera are not used for after approx. 80 seconds, the SB-28 shuts off automatically to conserve battery power. This is called the standby function.

Canceling and setting the standby function

1

2

Press the = button for approx. 0.5 sec. to turn the SB-28 off.

Hold down the µ button as you press the = button.

—The SB-28’s standby mode indicator : on the LCD panel appears when the function is set and disappears when it is not set. Perform steps 1 and 2 to cancel it or reset it.

•The standby function is preset when the SB-28 is shipped from the factory. (Check that the standby mode indicator : appears on the LCD panel when the SB-28 is turned on.)

When carrying the SB-28 in your camera bag with the standby function set, make sure to turn off the flash unit to avoid accidental battery drain.

To turn the SB-28 on again after it enters the standby mode, you can:

•Lightly press the shutter release button (except cameras in Group VII).

•Press the ~ button on the SB-28.

•Press the SB-28’s = button.

15