Relay

Receivers can be configured to relay transmitter commands to another receiver, increasing transmitter range and allowing signals to be transmitted around obstacles.

Transmitter

Relay

Receiver

1Configure the relay.

On the unit that will act as the relay, slide the Tx/Rx/OFFswitch to Rx. Press the MENUbutton to display the menus, then highlight SPECIAL and press 2. Highlight RLY and press z to configure the unit to act as a relay.

2Configure the remaining units.

Slide the Tx/Rx/OFF switch on one of the remaining units to Tx to configure it as a trans- mitter, and the switch on the other unit to Rx to configure it as a receiver.

3Take photographs.

Position the units. When the shutter-release button on the trans- mitter is pressed all the way down, the relay unit will pass the sig- nal to the receiver, and the receiver will release the shutter on the camera to which it is connected.

21