USER MANUAL
ENGLISH
ENGINE COOLANT LEVEL CHECK
1.Drive the machine on a solid and level ground, then engage the parking brake (21, Fig.
2.Turn off the engine, by turning the ignition key (17, Fig.
3.Open the engine hood (5, Fig. F).
WARNING!
The coolant line is pressurized; do not perform any check until the engine has cooled down and, even if the engine is cold, pay careful attention when opening the plug (1, Fig. AD) of the tank (2).
4.Check that the coolant level in the tank (2, Fig. AD) is between the minimum and maximum marks, as shown in the Diesel Engine Manual. If necessary, unscrew the plug (1, Fig. AD) and top up.
5.Coolant components:
•50% of AGIP antifreeze
•50% of water
6.After top up, tighten the plug (1, Fig. AD).
7.Close the engine hood (5, Fig. F).
FUEL FILTER REPLACEMENT
1.Drive the machine on a solid and level ground.
2.Turn off the engine, by turning the ignition key (17, Fig.
3.Engage the parking brake (21, Fig.
4.Open the engine hood (5, Fig. F) and fasten it with the support rod (6, Fig. F).
5.Replace the fuel fi lter as shown in the Diesel Engine Manual.
6.Close the engine hood (5, Fig. F).
CAB AIR FILTER REPLACEMENT (*)
(*)Only for machines equipped with cab and climate control system
1.Drive the machine on a solid and level ground.
2.Turn off the engine, by turning the ignition key (17, Fig.
3.Engage the parking brake (21, Fig.
4.Inside the cab, remove the screws (1, Fig. AE), then remove the panel (2).
5.Unscrew the knobs (1, Fig. AF) and remove the panel
(2).
6.Remove the cab air fi lter (1, Fig. AG).
7.Install the new fi lter (1, Fig. AG) with the arrows (2) pointing in the direction shown in the fi gure (direction of the air fl ow).
8.Perform steps 3 and 4 in the reverse order.
FUSE REPLACEMENT
1.Engage the parking brake (7, Fig. E).
2.Turn the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
3.Remove the transparent cover of the fuse box (23 or 24, Fig.
4.Install the transparent cover of the fuse box (23 or 24, Fig.
SAFETY FUNCTIONS
The machine is equipped with the following safety functions.
REVERSE GEAR BUZZER (OPTIONAL)
The machine is equipped with a sensor and a buzzer to indicate that the machine is moving in reverse.
SENSOR FOR ENGINE
The machine is equipped with a sensor that do not allow for engine start up when the drive pedal is pressed.
SENSOR FOR ENGINE
The machine is equipped with a sensor that do not allow for engine start up when the operator is not on the driver's seat.
SR 1800S D 2WD
23
