Nortel Networks Passport ARN Routers manual Connecting to the X.25 PAD Interface

		Installing the ARN
Table 1-2.	V.34 Front-Panel Modem Adapter Module Defaults
Modem Signal/Parameter		Default Value
Clear To Send (CTS)		On
Data Terminal Ready (DTR)		Depends on the modem type. Set the modem to
		answer incoming calls when DTR is active.
Data Carrier Detect (DCD) or		On while carrier is present (the ARN uses DCD to
received line signal detection		detect modem connect and disconnect).
(RLSD)
Data Set Ready (DSR)		On
Ready to Send (RTS)		Ignore
Synchronous/Asynchronous Mode		Asynchronous
AutoAnswer		Set on n rings with DTR active (n must be greater
		than 0).
Local Character Echo		Off
Supervisory Functions		Off
Baud Rate		28800
Data Bits		8
Stop Bits		1
Parity		None

Connecting to the X.25 PAD Interface

To support X.25 PAD applications, the ARN router requires the following hardware:

•ARN X.25 PAD adapter module

•Breakout box

114200-E Rev 00 1-21