Manuals / Nortel Networks / Communications / Cordless Telephone

Nortel Networks NT8B45AAAB, T7406 Installing the Base Station, Base Station Features, Antenna

Models: NT8B45AAAB T7406

1 56

Download 56 pages 35.69 Kb

Page 21

Installing the Base Station / 21

Installing the Base Station

This section describes the base station and:

•how to mount the base station on a wall

•what programming is required before you connect the base station to your system

•how to connect the base station to your system

The T7406 cordless telephone operates on the same principle as a two- way radio. Therefore, the location of the base station affects the range of reception. The base station should not be installed where radio waves are blocked or reflected, such as next to a filing cabinet.

For optimal performance, install the base station at least 2.4 meters (eight feet) above the floor. Always position the antenna at a 90° angle to the base station.

Base Station Features

This section illustrates the base station for the T7406 system.

Antenna

Base antenna (90° to base

station)LED indicates base station has power

Note: When power is connected to the base station, the LED on the front of the unit starts flashing. During operation the LED flashes every second to indicate that the unit is receiving power.

T7406 Installation Guide

Image 21

Nortel Networks NT8B45AAAB, T7406 manual Installing the Base Station, Base Station Features, Antenna

Contents

T7406 Cordless Telephone Installation Guide P0942257 Contents Low battery Safety Important Safety Instructions Installation Use Contents Provisioning the T7406 Operational BandwidthsOperational Parameters Installation Site Parameters Telephone-to-Base Range RF LANs Radio Frequency Local Area NetworksEnvironmental Layout Considerations Combination Office/Warehouse Environments Unsuitable for the T7406 Battery Charge Controller Powering the T7406OFF SpecificationsImportant battery pack information Radio range and coverage considerations About your T7406 telephoneSecurity of Conversation Density and InterferenceSpare Parts T7406 Parts ListsHandset Overview Out of range... message appears Handset Signal DetectionDisplay Handset FeaturesInstalling the Base Station Base Station FeaturesAntenna Mounting Bracket T7406 Pre-installation ProgrammingBefore you start Mounting and Connecting the Base StationCharging the T7406 Battery Pack First-time Charging Handset Power Low batteryRecharge Handset Configuration Important First-time Installation InformationBattery levels Identifying the Handsets to the System Assigning the Handset to the Base Station Using the Handset Display Buttons Configuring the First Handset to a Base StationConfiguring the Handset ID Number Changing the Handset ID Password Assigning the Security Code Setting Handset Features Configure the next handset to the base stationRing Type Lock Handset Ringer VolumeLanguage Handset System Feature Notes36 / Setting Handset Features Button Mapping on the Handset Memory buttons Programming memory buttons Button Inquiry System Feature codesHandset Asleep Mode Feature Conditions Handset Asleep Save Battery ModeMake and Answer Calls Make a callAnswer calls Mute microphone Hold callsCustomize a handset Helpful hintsBacklight On/Off Assigning the Security Cleaning battery contactsInstalling the T7406 Handset Accessories Installing the T7406 Handset Accessories Optional accessories Leather carrying casesHeadset Compatibility Headset installation Canadian Regulations Regulatory informationUS Regulations Federal Communications Commission FCC NoticeFor Class a Host equipment EMI/EMC FCC PartSafety Important Safety InstructionsFor Class B Host equipment Use Installation54 / Regulatory information Regulatory information