Northern Industrial Tools S500 Electronically Controlled Cameras, 124, Shooting, Troubleshooting

Troubleshooting

Problem	Cause/Solution	c
Date not appearing on pictures	Date does not appear on movies or on	56, 35,
even when [Date imprint] is	pictures taken using P, N, F, [Contin-	38, 40,
enabled	uous], when [On] is selected for [BSS], or	86, 88,
	shooting in anti-shake mode.	42
Camera settings reset	Backup battery is exhausted; all settings	102
	were restored to their default values.

Electronically Controlled Cameras

In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the battery, and then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon representative. Note that disconnecting the power source as described above may result in the loss of any data not recorded to internal memory or the memory card at the time the problem occurred. Data already recorded will not be affected.

Technical Notes

124

Shooting

Problem	Cause/Solution	c
No picture taken when shutter-	• When camera is in playback mode,	26
release button is pressed	press i or the shutter-release but-
	ton.
	• When menus are displayed, press	10
	m.
	• Battery is exhausted.	20
	• When flash lamp blinks, flash is charg-	29
	ing.
Camera cannot focus	• The intended subject is one with	25
	which autofocus does not perform
	well.
	• Set [AF assist] in the setup menu to	108
	[Auto].
	• Focus error. Turn camera off and then	20
	on again.
Pictures are blurred	• Use flash.	28
	• Use anti-shake mode.	42
	• Use high-sensitivity shooting mode.	33
	• Use vibration reduction.	107
	• Use A.	88
	• Use tripod and self-timer.	30