6.Repeat this removal procedure for each of the remaining image drum units.
7.Look into the printer to check whether any sheets of paper are visible on any part of the belt unit.
4
3
2
1
CAUTION!
Do not use any sharp or abrasive objects to separate sheets from the belt. This may damage the belt surface.
(a)To remove a sheet with its leading edge at the front of the belt (1), carefully lift the sheet from the belt and pull it forwards into the internal drum cavity and withdraw the sheet.
(b)To remove a sheet from the central area of the belt (2), carefully separate the sheet from the belt surface and withdraw the sheet.
(c)To remove a sheet just entering the fuser (3), separate the trailing edge of the sheet from the belt, lift the fuser pressure release levers (4) up and press toward the rear to release the fuser’s grip on the sheet, and withdraw the sheet through the drum cavity area.
NOTE:
If the sheet is well advanced into the fuser (only a short length is still visible), do not attempt to pull it back.
Troubleshooting > 95