%2.2 Service Tab ?2.2 Service Tab • This portion of the DOS Operator Panel is available to service personnel only.
• At the DOS prompt, enter: OL600 \S. When the Operator Panel appears, click on Service or press the
ALT and e keys.
(1) Head Drive Time
• Sets the drive time of the LED head using a scroll bar.
• For setting instructions, see page 4-3.
(2) LED Array
• Leave at default setting2560 Dots.
• Alternate setting is for future development.
(3) LED Wires
• Leave at default setting1 Wire.
• 2 Wire settting is for future development.
• Incorrect setting (2 Wire) causes two copies of the page image to be printed side by side.
(4) Climate
• Adjusts fuser for environmental conditions.
• Settings: +1 (default), 0, 1.
(5) Print Start Position
• This setting is for shippingdo not change it.
(6) Market Place
• Set at the factory for the region the unit will be shipped to: ODA (US default): North & South America
OEL: Europe Non-Europe 1: Australia Non-Europe 2: Singapore, Far East
• Must be set to ODA for proper default settings for language, symbol set, page size, etc.
• If incorrectly set, menu page will read "OL600ex" or "OL610ex."
(7) Revision Information
• Displays revision/code numbers for the firmware, the engine, and the CPU.
• This information may be needed to determine the applicability of product updates and procedures
outlined in Product Bulletins.
(8) Count Information
• Displays usage information as follows:
Drum:
Number of revolutions of the image drum currently
installed in the unit.
Drum Total:
Total number of revolutions of the unit.
Page:
Total number of pages
printed by the unit.
OKI OL600/610ex (96-01-18