%3.3.3 LED Head
3.3.3 LED Head
(1) Open the stacker cover.
(2) Remove the flexible cable (LED) 1 from the PC connector 2 of the LED head 3.
(3) Remove the LED head by flexing the left side of the upper cover away from the retaining clip.
Note:
Be careful to not lose the frame ground clip 4.
Note:
• Be sure not to directly touch or push the SLA (lens) part of the LED head.
• After mounting the new LED head, set drive time of the LED head according to the marking on the LED
head (see 4.2.1).
• For the installation of the flexible cable (LED) 1, install the PC connector 2 to the flexible cable (LED) 1
first, then connect the LED head 3 to the PC connector.
• When installing a new LED head, be careful not to lose the frame ground clip 4.
OKI OL600/610ex (96-01-18