Chapter 4%4.1 Maintenance Menus and Functions
4. ADJUSTMENT
This chapter describes the adjustments necessary when replacing a part. The adjustments are made by
changing the parameter value set in EEPROM on the Main Control PCB. The parameter can be set from
the operator panel (OL610e/PS only) or from the DOS Operator Panel software (OL600e, OL610e only) .
4.1 Maintenance Menus and Functions
4.1.1 User Maintenance MenuOL610e/PS
End-users can use this mode. To enter the user maintenance menu, turn the printer on while holding
down the MENU button.
Functions:
• Hex dump • Drum counter reset
• Menu reset • Operator panel menu disable
• X-adjust / Y-adjust
Detailed descriptions of these functions are provided in Appendix C, Software Diagnostics & Adjustments.
4.1.2 System Maintenance MenuOL610e/PS
Note: Only service personnel should use this mode; it should not be released to end-users.
To enter the system maintenance menu, turn the printer on while holding down the RECOVER key.
Functions:
• Page count display • Loop test
• Page count printing enable/disable • EEPROM reset
• Rolling ASCII continues printing
Detailed descriptions of these functions are provided in Appendix C, Software Diagnostics & Adjustments.
4.1.3 Engine Maintenance MenuOL610e/PS
Note: Only service personnel should use this mode; it should not be released to end-users.
To enter the engine maintenance menu, turn the printer on while holding down the FORM FEED and
ENTER buttons.
Functions:
• Head drive time setting • Drum count total display
• Printing start position setting • Engine reset
• Drum count display • Factory adjustment
Note: "Printing start position setting" is for shipping. Do not change its default value.
Detailed descriptions of these functions are provided in Appendix C, Software Diagnostics & Adjustments.
4.1.4. DOS Operator PanelOL600e, OL610e
(1) Settings Tab
At the DOS Prompt, enter OL600, then click on Settings.
Functions:
• Reset EEPROM, Menu, Drum count
• Print position adjust
Detailed descriptions of these functions are provided in Appendix C, Software Diagnostics & Adjustments.
(2) Service Tab
Note: Only service personnel should use this mode; it should not be released to end-users.
Functions:
• Head Drive Time • Revision information
• Climate • Count information
• Market Place At the DOS Prompt, enter OL600 \S , then click on Service.
Detailed descriptions of these functions are provided in Appendix C, Software Diagnostics & Adjustments.
OKI OL600/610ex (96-01-18